Repair Technician Job Vacancies in Nashik

Key ResponsibilitiesDiagnose, repair, and test industrial electronic equipment and drive systems.Troubleshoot and repair AC/DC drives, VFDs, servo drives, soft starters, and power supplies.Analyze circuit boards and electronic components to identify faults.Perform component-level repairs on industrial PCBs.Conduct preventive and corrective maintenance on industrial automation equipment.Test repaired units using diagnostic equipment and load testing systems.Read and interpret electrical schematics, circuit diagrams, and technical manuals.Support installation, commissioning, and servicing of industrial electronic equipment.Maintain repair records, service reports, and technical documentation.Guide and mentor junior technicians in troubleshooting and repair activities.Coordinate with customers and production teams to resolve technical issues efficiently.Ensure compliance with workplace safety and quality standards.

Hiring for 1 Maintenance Operator Job in Nashik,Nashik Road,Satpur MIDC Nashik,Satpur Nashik,Ambad MIDC Nashik with minimum 3 Years Experience,Required Educational Qualification is : Higher Secondary, Vocational Course, Diploma, Other Bachelor Degree with Good knowledge in PLC,Preventive Maintenance,Repair,Plant Operations, Electrical Maintenance Technician,Mechanical Maintenance Technician,electronics maintenance etc.

Key ResponsibilitiesDiagnose and repair industrial electronic equipment at component and board level.Troubleshoot and repair AC/DC drives, VFDs, Servo Drives, Soft Starters, and motor control systems.Perform fault finding using multimeters, oscilloscopes, insulation testers, and other diagnostic tools.Repair and test PLC modules, HMI panels, industrial power supplies, controllers, and automation equipment.Analyze electronic circuit diagrams, schematics, and technical documentation.Conduct functional testing, burn-in testing, and quality verification after repairs.Identify root causes of equipment failures and recommend corrective actions.Support onsite troubleshooting, installation, commissioning, and maintenance activities when required.Maintain repair records, service reports, and technical documentation.Coordinate with engineering, maintenance, and customer support teams to resolve technical issues.Ensure compliance with electrical safety standards and company procedures.Mentor junior technicians and provide technical guidance on complex repairs.

Key ResponsibilitiesAssembly & Installation: Putting together electronic systems or mechanical parts based on technical drawings, schematics, or blueprints.Troubleshooting & Repair: Diagnosing faults in malfunctioning equipment and performing necessary repairs (e.g., replacing a blown capacitor on a PCB).Testing & Calibration: Using tools like Multimeters, Oscilloscopes, and Signal Generators to ensure products meet specified standards.Preventive Maintenance: Performing regular checks on machinery or systems to prevent future breakdowns.Soldering & Rework: (Specific to Electronics) Hand-soldering components onto PCBs or performing rework on surface-mount devices (SMD).Documentation: Maintaining logs of repairs made, parts used, and test results for quality control. Required SkillsTechnical Proficiency: Mastery of hand tools and diagnostic software.Manual Dexterity: A steady hand for working with very small components (crucial for PCB work).Reading Schematics: The ability to look at a circuit diagram and identify the physical components on a board.Attention to Detail: Precision is vital; one wrong wire or a cold solder joint can ruin an entire system.Safety Awareness: Strict adherence to safety protocols to prevent electrical shocks or mechanical injuries.